u/rail16

All very vague details for the film but it would have been watched during the summer in the early to mid-eighties I think as I was most likely in single-digits for my age. And I think more likely Showtime but it's possible it could've been Cinemax.

For some reason a bunch of 80's dude-bro misfits have a shop on the beach, most likely California, and sell swim ware, sort stuff, and prolly skater gear.

Because it's the 80's there are lots of tit shots as well as light sexplotiation and fat shaming. One scene had the dudes installing a two-way mirror in the changing room to curb 'theft' but we know it's to perv on the women. And when the dude that wasn't sure goes to finally perv and check it's a fat woman putting on a bikini (hilarity ensues).

Near the end of the movie they host some sort of race along the beach with women in bikinis from their shop. However, there is a gotcha! The shops had lots of thread they used to make the bikinis because the shop used to be a supply shop for medical stuff, but the thread they used was disolving suture thread and the bikinis fall apart as the women are running on the beach. Of course that scene is in slo-mo.

Last month had an nozzle issue with a red Anycubic filament that I was able to sort on my own. Heated up the nozzle and was able to manually feed through after some work. That cleared things and no issues for a month or so after.

However, yesterday I was using the same red to start a new print, was going to be grey with a red highlight as the last layer/rim of the little box. I got the same error as before, 11851, which the Anycubic folks have a nice Wiki page it that I used the previous time is messed up. But this time the same things didn't work. T

Using the same page as a guide I removed the nozzle and could see that it was clogged up bad. I still had all the stuff that shipped and used the little nozzle cleaning tool but that didn't help since it was clogged.

Overall, I used a lighter and eventually a heat gun, to warm the nozzle up enough to use the cleaning tool to unblock all the things. I'm doing the spider test print that stored in the printer memory right now and it's doing well with a white filament.

All of that is to ask, what things/tools should I have on hand to make my life easier for when this happens again?

I've ordered some replacement nozzles as well and they should be here by the end of the week.