Recently, I decided to assemble my 3D printer. I'm curious to know what challenges this combination might bring to me. Could everyone share their opinions? Have you noticed any drawbacks of the products I chose from this combination? As shown in the picture below.
Recently, I have decided to purchase the Manta M8P and CM4 to assemble my 3D printer.I wonder what challenges this combination might bring for me. Could everyone share their thoughts on this? Have you noticed any drawbacks with the products I chose from this combination?
Hello, everyone. When I combined the Octopus hardware board with the TMC series boards, I encountered some practical problems in the motor section (such as overheating and noise). Could you please specifically tell me how these problems occurred? Or are there any areas where the boards need improvement?
hello，everyone.I'm the PM of the MANTA M8P board. Recently, I have summarized the issues that have arisen with this board, such as problems with the MOSFET heat dissipation on the PCB, issues with signal communication, and the inconvenience of replacing the eFuse when it melts. I need to gather more information to carry out this hardware upgrade maintenance. I hope you can provide me with more suggestions so as to enhance everyone's experience. thank you.
