What percentage does the robot head back out to finish his mow job if he pauses during the mowing session due to low battery? Went from 20% to 55% still hasn't returned.
Any official info on what percentage he returns to the job?
Using a mac if it makes a difference, printer on same network etc. All connected and setup as it should and uploads work only sometimes recently.
Issues with intermittent uploads to printer hanging. Just starts upload stays at zero like it never connects to printer or something.
To fix I have to close Elegoo slicer, reopen, delete printer reconnect and then reupload and then maybe it works. Sometimes have to do this in different orders and I can get it to work then other times it works with no steps at all.
This is a new issue, worked for months until just last week.
Elegoo slicer is up to date, printer is one update behind as I am still waiting for my canvas unit (did update printer before but had fan error appear due to hotend not having new parts for canvas installed, support advised a roll back)
Not sure if anyone else having this issue or I you can suggest a fix?
Using a local internet provider in Ireland Vodafone, ip address is based in Ireland, no Vpn in use.
My Google location is set to Ireland.
All of my search results are for Italy - how do i figure out why this is happening and fix it?
I can see an option for "channel" but when I try to map it it asks me to set a no go zone - can anyone advise will it know how to go between zones or do I need to some how map it to know where to enter the lawn from? There is a large hedge between the two zones - above the track where it will need to go to get to this 2nd zone is a monster of a tree...
PS top zone will be redrawn when it stops raining.
Has anyone else gotten this error since the recent update (the canvas update) I did the update yesterday and have had my printer and used it quite a bit for about 3 months but today I set a small print and I got this error.
I followed the instructions relating to this error, and it still showing when I tried what it said to do. The fan does seem to be laboured.
Anyone else had this since the update? Is it safe to continue to print? (it seems to still be working away fine)
I have messaged support to see if I can get some official help.
Running fully stock re firmware and using elegoo slicer if that helps.