u/IAmSuperCookie

I recorded a video right after I turned it on using my Nest thermostat. Around the 3 minute mark (3 minutes 22 seconds/3:22) it just turns off completely. After that it keeps trying to cycle on and off

Here's the youtube link: (https://www.youtube.com/watch?v=OZQKbkS1z-c&feature=youtu.be)

And here's the youtube link where it keeps trying to cycle on and off. It will do this until I turn off everything. (https://youtube.com/shorts/0GZmASluwfo?feature=share)

Now for the details: last night I noticed that my AC wasn't blowing inside the house. I think that the condensor coil did freeze because when I looked at it last night, I saw water dripping down. I turned the unit off overnight and let it melt. This morning, I went up to view it.

In the video, I have already removed any air filters to make sure that they couldn't cause the issue. I have already ordered new capacitors from Genteq that should be here tomorrow night.

Blower fan spins freely by hand. Capacitor was replaced 4 years ago. IT's a JARD 440/370/8 AUuF

Thoughts on what's going on?

Hope this helps as documentation for users struggling to get their mics to pair with receivers.

I struggled for several hours trying to get my Rode Wireless Mic to pair to the transmitter. I followed the instructions on Rode's website but they are not complete or something is missing because they do not lead to the solution. As a result, I thought it would be useful to others to be able to easily search for a solution if they struggled like I did.

There's a comment on this thread by User Vkketv

Rode wireless me not pairing since today’s Rode central update : r/rode. I've pasted the comment below

In short, you need to press a button after putting your receiver in pairing mode to "confirm" that the receiver should be in pairing mode. Also... what a stupid design setup. For my Gen 3 Mic, once I put it into pairing mode, I pressed the main button once to confirm pairing mode and it connected immediately. It did go into "record" mode as well, but that was a non-issue once it paired up.

I don't want the original thread to be deleted and his advice lost forever, so I copied his original comment below:

Sorry for resurrecting this issue thread, but I was struggling with this issue for few hours now and found a "solution" that worked for me.. This thread was the one of the very few that popped up on google search on this issue..
Google search for "rode wireless me manual" directed me to rode's lacking manual https://rode.com/en-fi/user-guides/wireless-me
There it doesn't say that you need to confirm the pairing from TX unit by pushing the TX unit's button once while units are blinking and search is on from the app on RX side.
The complete guide including confirmation of pairing was found on the rode help site:
https://help.rode.com/hc/en-us/articles/7092976490511-How-to-Pair-the-Wireless-ME-Transmitter-to-the-Receiver