The car is currently at the insurance examiner and I'm waiting for more info. Was just wondering if anyone had any guesses on the extent of damage since I was thinking of buying it back if it gets written off and fixing it up.
I'm struggling to get rid of this horizontal line on this print, it starts where the bottom of the inside ends. I've tried everything I can think of (dialing in flow rate and dynamics, changing max volumetric speed from 16mm³/s to 10mm³/s, adding a slight fillet to the inside, changing bed and nozzle temps from 200C to 215C, and 60C to 65C, changing from 6 walls to 3 even though I need the strength, changing to less infill, slowing the print speed) I'm really struggling to get this line to even become more faint.
On all sides the top seems to swell outwards
Print details
Slicer: Bambustudio
Printer: Bambulab A1
Filament: Esun PLA ST
Nozzle:0.4mm
Nozzle Temp: 215C
Bed Temp: 65C
Infill 20% Cubic
Outer Walls: 3
Top shell layers: 5
Top shell thickness: 1mm
Top paint penetration layers: 5
Layer height: 0.2mm
Line width: 0,42
Inner wall line width 0,45
Wall generator: classic
Order of walls: inner/outer
Outer wall speed: 45mms
Inner wall speed: 200mms
Sparse infill speed: 270mms