u/AHarmlessCat

MilESEEY TNV10 Pro Disassembly?

This is probably a very niche question, but I own a MiLESEEY TNV10 Pro version, and would like to try disassembling it to make my own DIY improvments. I find it hard to believe it needs to be so large and heavy. Its not bad as is, but I'm experienced in tinkering with my gear and would like to improve it slightly with some 3d printing to possibly make a lighter and more compact housing. I can't see any obvious ways to disassemble without being destructive. Has anyone by chance has experience with this?

reddit.com

u/AHarmlessCat — 2 days ago

▲ 1 r/FixMyPrint

Streaks coming from z seam.

Bambu Lab P1S, Orcaslicer, Esun PLA+

I have been trying to use arachne walls since they improve almost every aspect of my prints. However I cant get rid of one major flaw. I get these streaks that always originate at the z seam, like on the hole in this print. I don't get anything like this with classic wall generator, and I feel like Ive tried every single setting at least once and wasted so much plastic trying to diagnose this. Any ideas?

u/AHarmlessCat — 5 days ago