u/A-Yoko

Since all the bodies are oriented at different angles, I’m a bit overwhelmed. In the last image, I added a sketch to show roughly what I have in mind.

I haven’t been able to find a suitable tutorial in the past few hours, and I’m not even sure what exactly I should be searching for.

Thank you very much for your support!

AM8 Klipper Bowden
SuperSlicer 2.5.59.13
dryed PLA
0.5 mm nozzle, 2h in use, 0.25 layer height
2.5mm retract, 0,3 z-lift, retract 150mm/s, deretract 220mm/s
Calibrated flow 98% and pressure advance 0.225s
Was good in the first few prototypes