u/88-BrickNose

Did not anticipate doing much bodywork to my print before paint.. but here I am.. minor setback, maybe 8 days or so. Lesson learned, bondo thinner prints before pulling from print bed..

Body came hot off the printer six days and eleven hours later, going to let normalize the next two days, then bondo and paint. Bed goes on the printer in the morning for the next 4 days!

Realistically, is this possible for a 1/10 scale crawler?

It’s a fake rock wall at one of the public parks in Arizona. It is steep, but does have some good ledges. I’m not an advanced crawler, just starting out. Probably scale it on 1-10 for advanced. Good part is the floor is extremely squishy lol

New cab for my Axial SCX10 I II III.. Final result of this build should be something of SEMA quality for the RCC world. Will post the build, and crawling videos along the way

First truck I built was a 7& flatbed 1/10 scale, decided to swap over to a 88 BrickNose which is currently on the 3D printer now.