u/rusty_bronco

I've found Marcy Quantaum mouldings P/N QM16L/QM19L replacement moulding that looks similar to the moulding attached to the Backlite on my 2003 Chrysler 300M. My question for you is, what adhesive would I use to bond it to the glass after the old moulding is cut off?

The problem with these old backlite's is the original mouldings get hard as a rock. I can find backlites from time to time but almost always with hardened mouldings.

https://marcyadhesives.com/wp-content/uploads/2025/06/molding-app-chart-poster-digital.pdf

Does it go off to a salvage/ scrap yard for whatever the Ins Co. will take or does it get relisted?

Can I use broker and do all the purchasing through them and still use copart for the vehicle transportation as they are the cheapest ($747.50). Or, is there a better way to keep fees as low as possible?

I have put together what I believe to be the correct final total less broker fees from copart. ($302.50 + broker fees) ABM broker fee is $299 + $35 membership.

I do have quotes from roadrunner transportation. ($1072.00) and through ABM (est $975.00)

Any suggestions as Copart fees "appear' to be cheaper. (ABM fees show as $859) Vs say $300~500 if I did it right for Copart.