I’m not familiar with bikes I’m just getting started out yesterday ironically when I started taking the plastics off and I had this bike just sitting for a month or 2 and it started leaking I guess last night from this bolt. Anything helps & thank you.
Ok so I’m redoing the 3 boxes I messed up on. First I’m gonna rotate the short sides so the grain is vertical. After that, am wondering if I put 4 and 4 screws on each side, plus glue and brad nails, is that my best bet? The very last picture is another design idea and I’d rather not do it that way because I want it to look as aesthetically pleasing as possible and kinda sorta prefer the other way better but please lend me advice as anything helps & thank you.
A customer wanted fabric lining for this planter. I drilled drain holes in the bottom. I was wondering if it makes any difference as to cutting a hole through the fabric right above the drain holes? Considering it’s already some thin burlap. And if I were to get some thicker burlap next time with less see through visibility, should I then cut a hole? Or does it really not matter? Also is thin or thicker better?