Dash support arm fix!
Hello s3xy fellows!
Since I got the s3xy dash (2nd batch) I always struggled with its support arm for 2 reasons:
- The glue kept unsticking from the trim, even though I did everything as instructed;
2)I couldn’t find a nice incline on the adjustment that would allow me to see the screen properly. I had to choose between it being too downward-facing (which led to bad viewing angle) or to have part of the screen being blocked by the steering wheel.
Therefore, I’ve ordered a Spigen car phone holder that goes exactly where the s3xy dash support would, but with no glue, it simply “clicks” into place on the trim.
Check the photos on the final result.
Conclusion: It fixes the 2 issues I mentioned above!! With this I have way more adjustment positions, including a lower one. The magnet on the holder perfectly matches the magnet on the back of the dash. It’s not going anywhere!
Ps: here’s the link for the Spigen support on amazon.es:
https://www.amazon.es/dp/B0FLRDQYV3?ref=ppx_pop_mob_ap_share