Constant bad extrusions with beads and gaps
For years my Prusa MK3S+ has been a dream and required hardly any adjustments or maintenance.
I’ve picked the hobby back up again, printing with PolyMaker matte PLA and my extrusions are just awful and I cannot seem to figured it out
So far I’ve tried
• cleaning the bed
• glue on the bed
• different filament
• brand new filament
• filament from filament dryer
• different models to print
• cold pull to clean nozzle (did clean some out, but hardly seemed like a lot compared to others I saw online)
• Z-adjust (currently set to 1.300 which it has been for nearly the entire time I’ve had it)
• releveled the bed
I’m feeling kinda crazy and can’t figure out what else to do aside from replace the nozzle?
Hoping others have banged their head against this same wall and have suggestions