u/eagle6705

My client has verizon obviously and I'm trying to determine what his connections are before I change anything. I"ll be honest, I'm use to optimum's setup for both fiber and coax going to a modem. and verizon where the only ingress is a coax. Having an ONT connect via coax and ethernet to once device is kinda mind boggling :)

He has a ONT I-211M-L and a G3100

From my understanding the G3100 is connected to the ONT via ethernet(wan) and coax.

The ONT's Coax is split to a cable box and the G3100.

So from my understanding

G3100 Wan port is internet obviously)

G3100 Coax is so the cable box can get live tv?

So is the ONT acting as a modem/gateway while the G3100 is the actual router?

What I want to do is

split the line going to the cable box to a moca25 adapter so i can add a mesh system and use that as a backhaul.

Alternatively I was just going to put the mesh nodes in with the main node connected to the G3100.

So my v3 plus is too close to the print bed.

What I'm doing is the following

1. Run Auto Level (the one in the begining)

2. Print with calibration off

3. Adjust Z offset in the bottom

   ## [prtouch_v2] ## z_offset = 0.830

4. Print Test

5. Repeat 3 and 4 if too close or too far.

So what are you guys doing to adjust the z offset.