u/Weekly_Judge_3441

Is there a way to keep the filament in your print head and stop oozing when calibrating? Im tired of removing the filament anytime I need to run calibration. If I leave the filament in when it runs the cleaning cycle it heats the nozzle up cleans then cools and cleans again but the filament always oozes out enough to where some is still stuck on the nozzle or has a little blob which then cause the calibration to be inaccurate.

Recently had 2 teeth extracted as one was very infected. Did 2 rounds of antibiotics before I was able to be seen by a dentist. Im now 9 days since dentist visit and have a slight pain (1/2 out of 10) at the extraction site and right lymph node. I went back in at day 5 they prescribed another antibiotic and mouth wash. How likely is it that a dentist would miss if the infection spread to my jaw bone? Or do I just go another week or two and see if everything calms down and goes back to normal?