Fresh DIY Grips Cutout For VXE R1 PRO!
I found a picture of the grips and measured them on my screen and then the physical mouse itself and then I used some tape to attach the paper onto the screen and drew the grips in a dark room. I then cut out the drawn grips from the paper and pasted them on the peel-off sticker behind the DIY grip sheet using glue and waited for it to dry.
I then proceeded to cut the DIY grip sheet according to the shape of the paper pasted onto it's back. When Finished, I peeled off the paper and the peel-off sticker of the sheet itself and then I pasted the cutouts onto my VXE R1 PRO.
to make it a little different from my previous grips I've made the same way, I even cut out a rectangle on the ring and pinky ringer area so the logo of the "VXE R1 PRO" is visible. it's not the cleanest because I used a simple pair of scissors and a cutting pen so I guess it did the job. Did it pretty well I would say.
The reason I use these Chinese DIY Grips is because they barely cost a dollar and work way better than any expensive thin grips that don't do absolutely anything when my hands get sweaty. But with these ones, they're pretty much always really grippy and somewhat even a bit sticky too. Heck, they're still sticky on my Haste 2 Wired that I've used for almost a year now.
Only 1 gram was added to the already 50 grams of this mouse so I didn't notice anything much, if anything it feels hell of a lot grippier, stable and more rigid than before, and the coating covered by these grips stays safer for longer so it's a win win.