Made a modeling mistake; looking for fixes.
Hey all. So, im working on magnatizing the main gun for my Invictor Tactical Warsuit. Im putting two magnets inside of each weapon options, and magnets inside the single joint the kit gives you (Dont worry, all my polarities are correct).
The issue is that, for each weapon, it would seems I did not drill out enough material for one of the two magnets. These magnets stick out a bit, with prevent the joint from sliding in and out clealny. Ive already applied glue to these magnets (well, except for the first one I did a dry fit on. It fit ao snuggly in the weapon that I couldn't get it out).
So, is there any remedy, or am I just kinda screwed at this point? Id hate to have to run the weapons partially split open since they cant close fully around the elbow joint.