I keep it in comfort mode, but it seem to keep resetting to normal despite saying it’s still in comfort. When I get back in, it feels rougher than when I left it and softens up when I re-select comfort.
I’m going to be 3d printing in my detached shed and I’d rather not spend the money to have a line professionally installed. I know cheaper extension cords can be a safety hazard so could I run one of those thick ones instead?
I do printing in an outdoor shed but being spring in the midwest, the temps are good enough to be comfortable leaving them in there. What about the 100+ degree summers or -40 degree winters though? Surely it needs heat in the winter, does it need ac in the summer?
I got some solid black ABS-like resin from sunlu and the prints have been translucent. I’ve tried shaking the bottle vigorously, but it’s the same result. My gray version of the same stuff is opaque. These are two different test prints before and after shaking the bottle.
I’ve been using Toro for over 10 years now, but they keep having supply issues and I always have to ask the pharmacy if the refill I’m buying is Toro or if they filled it with something else. It’s starting to be a pain so I want to switch manufacturers. Has anyone experienced changes when switching manufacturers?
I’m reassembling a Camry and couldn’t figure out why the door lock wasn’t going into the door latch assembly because there was no place for it to go. After a day of troubleshooting, I found out that whoever worked on it last put the rear latch and internal handle in the front door and vice versa! I didn’t even realize during disassembly because the door handles just popped out like normal.