Kobra X print bed adhesion is no longer good.
Hey, I’ve had a Kobra X for about a week now. For the first 20 or so prints, I had absolutely no issues, and every print worked perfectly right off the bat. Now, however, I seem to be slowly running into adhesion problems. Or could it be the filament? The filament was all brand-new and came in sealed packaging. I’m using Anycubic PLA filament. I run the bed leveling routine before every print. I’ve already tried wiping down the bed with a paper towel soaked in isopropyl alcohol, followed by brushing it with the fine brush that came with the printer—but unfortunately, that didn't help.
Printer: Anycubic Kobra X
Filament: Anycubic PLA
Settings: Standard 220/60°
Slicer: AnycubucSlicerNext
u/Madoonis — 3 hours ago