Anycubic m7 base layers problems
so long story short I have been using the m7 for months with no issues, and now I have started getting partial support fails and I have noticed the left side of my print beds base layers are very thin which means they are not printing properly, I am using a pre supported model and the first 2 times I done this piece a month ago was fine but now twice in a row I've had supports fail and now im seeing base layer on that side not print properly, I've re leveled my bed, I've made sure my screen isnt damaged, i have just changed out the fep and it just doesn't make sense for 1 side of my plate to print perfectly fine with the base layers are rafts and this side have such thin layers you can see through to the build plate, i have attached pics and photos of my resin setting and in case you need to know i am using anycubic standard v2 resin