u/K_Wright1

I recently picked up a prusa mk3s from facebook marketplace. Have been trying to get the print settings dialed in and every-time I try to print a benchy it will do the outside just fine but every time it seems to catch the filament and starts to spool around the nozzle, so then I cancel the print and brush the nozzle to remove the accumulated filament. Any help is greatly appreciated! TYIA

Model: Prusa MK3s
Filament: OVERTURE PLA Filament 1.75mm
Using the default prusa temps of 215 and 60
Print speed is currently set to the default prusa 100%
Used Cura Slicer