Could someone please explain to me how and why these small holes occur?
Both prints are made from PLA. The issue appeared for the first time on the red print, and then again the day before yesterday on the orange one, just not as widespread. Maybe it’s a coincidence, maybe not, but I noticed that this problem only started appearing after I dried the PLA.
And please ignore the terrible support leftovers. 😅 If you need any more information, just ask, because I honestly don’t know what else to add besides it’s my first printer, which I’ve owned since December.
•Bambu Lab P1S
•Bambu Studio
•PLA from Bambu Lab
•Nozzle: 230° Bed: 30° (Cool Plate)
•Speed:
Initial layer: 30 mm/s
Initial layer infill: 70 mm/s
Outer wall: 150 mm/s
Inner wall: 300 mm/s
Sparse infill: 400 mm/s
Internal solid infill: 300 mm/s
Top surface: 150 mm/s
•Layer hight: 0,08 mm
•Retraction settings: standard Bambu settings (I can post a picture if someone doesn’t know what it mean)