I just ran into this issue today using a Canon R6 III. For some reason it shows No Input when shooting 7k 23.976fps RAW, but it displays 7k 29.97fps+ RAW just fine. I tried two HDMI cables that are capable of 8k 60fps. Both had the same issue. Both the camera and monitor firmware are up to date. I'd prefer to capture interviews in 23.976fps. Is there any workaround for this?
I have two floors set up on the Roborock Q10 S5+, upstairs and downstairs. I had the vacuum clean upstairs, but one door was closed so it couldn't access one of the rooms. After it finished I opened the door and had it clean that room. It stopped before finishing cleaning that room and when I checked the map, that section of the map was resized and tilted at an odd angle. I tried running it again and realized the rest of the map of that floor was misaligned and it was showing walls where there were none.
Eventually I decided to delete upstairs to scan the entire floor again. However, when I deleted upstairs, it deleted downstairs instead! I know I didn't delete the wrong map because I made sure to check the name and layout before. I only checked because recently, the room names keep resetting for upstairs. I've tried renaming them again, but it randomly keeps resetting.
So now I have to rescan both floors and customize them all over again. Is there anyway to backup and restore floors so I don't have to do this again?