u/IrishCrypto21

The FDM Titan family grows larger.....

Reaver finally fully together (leg armour out of shot), painting to start soon, with paint due to continue on the Warhound. I have changed ideas several times on the hound, so painting had stalled for a bit.

I have a bunch of ideas for the Reaver, since I dont play 40k but prefer building and painting, I dont have to stick to an official or coherent scheme to match an army.

The Warlord has been an experience so far but a backlog of family ordered prints and the last few bits to finish the Thunderhawk build too means I'll pause once the main upper body parts are finished and resume later.

Everything printed on Bambu A1 Mini with eSun PLA+ @ 0.2 layer with a 0.4mm nozzle.

First larger scale print and paint. Bambu A1 Mini 0.12 layer height using eSun PLA+.

Further refinement needed for layer lines on the helmet and backpack but otherwise pleased.

Some edge highlights on legs and hammer handle required and a few small areas to touch up before calling it fully done.