Standard k2 with cfs , printed an ABS print earlier and used glue and i cleaned the bed afterwards with soapy water. After that PLA prints don’t stick at all, i cleaned it with IPA 2 times still nothing , i cleaned it with only warm water and after IPA and they still don’t stick. I’m loosing my mind
After a request ,i’m posting the results from my previous post about printing ABS on my standard k2
Standard k2 printing Bambu ABS like it’s nothing !
Preheated the chamber to 40C and used some random glue stick i found in my drawer, prints like a charm !
Hello guys , i have a standard k2 and i bought ABS and TPU 95A to try them out. The ABS printed surprisingly well even tho i dont have an active chamber heater, they were only the small flow calibration rectangles but they didn’t warp at all. The TPU on the other hand , man i’ve searched it up on reddit , google and youtube but i can’t figure out how to print that thing! I’ve printed myself those relief tabs that you put in the extruder so the spring isn’t pushing but i couldn’t even get the TPU to purge! I put it on the side spool holder and fed it straight from the top with no PTFE tube like the wiki mentions and the little blue light turned on in the extruder but the TPU just didn’t get in. I would really appreciate some tips on how to make it work, thank you !!