u/IDuranTee

Guys hate me or not,

but after I fried my about fifth VTX (all SpeedyBee VX800) I decided to ask the community for help.

According to my FC-layout I suggest that I've the options whether the output to my VTX is 10V or 5V, my case would be the latter. I would just have to bridge the pads accordingly (see photo).

Now... whenever I plug in my LiPo the VTX runs hot as expected. BUT ITS GETTING REALLY HOT like the VTX literally turns into soup! The components on the VTX board literally leave their original place. Even though that thing runs only on 25mW!...

And when I try to turn on pit mode, the slider turns back to off in the configurator...

I'd really appreciate any kind of help and sorry if yall think the answer is clear/question is dumb.

Have a nice weekend.

See attached photo

Long story short:
I managed to get the Hekate bootloader running and partitioned my SD card for emuMMC. Somehow, I was able to drag the slider to create two 32 GB partitions. In Hekate, I now get the green “Enabled!” message under “emuMMC Info & Selection.”

I’ve tried both:

• using AIO packs (HATS by Sthetix), and
• installing Atmosphère manually.

Unfortunately, neither method worked, and Atmosphère still won’t boot.

Another question:
How can I check my current HOS version?

I’m wondering if my HOS version might be too new for the latest Atmosphère release.

Any help would be greatly appreciated.

See attached photo when trying to boot into EMUMMC CFW: