u/Hour_North_6276

08 TL: recently changed my rear shoes as the e brake was not holding/stopping the car. I adjusted the brake cable under the center console pulls up 6 clicks as well as manually underneath the rotors via the spring under. Fully maxed out until the wheel could not turn then dialed it back 8 clicks. Pulled the e-brake with the rear lifter and the wheels did not turn unless input the e brake down. I assumed good I fixed the issue, went for a test drive and e-brake still doesn’t hold/stop the car and hear a weird noise with the e-brake engaged , it slows down the car very slowly. Video for reference.

Edit: issue resolved

Hey Guys, ran into a situation I changed my ball joints and ABS sensors(since they were corroded and stuck) not so long ago since then my ABS and VSA lights remain on the dash. I made sure there was no debris anywhere before putting the knuckle ring back , I sanded the hole where the abs sensor goes in, everything looks perfectly fine. Fast forward days later I now have som ABS codes showing up and I am now not sure what it could be.