u/Historical_Outside35

Hey all, I have purchased a 1990 Goldwing Aspencade. Super clean, very comfortable, love it.

However, it needed a new rear tire, so I took the wheel to a shop, had it swapped, all is good.

When I was removing everything, I noticed the top bolt on the caliper was just hand tight.

Didn't think much of it.

When reinstalling everything, I noticed it would not tighten down, appears to just be stripped out.

What is going to be the move for fixing this? Replace the caliper or any way to tap the hole out? It has that kind of special bolt so I'm not sure that's an option but wanted to ask here.

If replacing it is the move, where is the best place to get one? eBay or can these still be bought from Honda?

Appreciate any help in advance!