Hey yall. So I have an.....oddish request for advice.
I recently bought an international semi. (long story)
One major issue I have with it i'm having is that international designed the bunk air system in a way I dont understand
I have 2 bunk blower motors. 1 for when the truck is running and one for when it's off (which is fine) My issue is that the truck off motor blows air in the bunk on the driver side and below the bed only and the other one only blows aire on the passanger side.
I was wondering if I could combine the airways to make it so both blow out all 3 spots.
it's set up like this
(s = source, v = vent, p = piping)
s v s
| | |
p - p p
| |
v v
I can take a picture too but the two pipes on the left connect and the middle one goes back up between the sources to blow out the vent. it's all the collapsable tubing but looks like at one point it was hard plastic pipes instead of flex.