u/Galindoja1

Can you guys please provide pointers? I’m wondering what went wrong here.

1. I turned off zigzag underlay and just left edge run enabled.

2. The letters stitched from the inside out as well.

3. Sharp 75/11 titanium needle was used and the hat was hooped correctly, so no registration issues from what I can tell.

4. No stabilizer used since it’s a Richardson.

5. I did change the density to 0.009 inch/0.23mm (maybe this was the issue or maybe the font isn’t the best?)

6. Bobbin is reading 27gf on the tension gauge

Is this a good deal? I spoke with the sales rep and he got me down to this number. The machine is “open box” but he noted that it was used for a class at their headquarters as was inspected by their technician before being resealed. So it was not sent to an actual consumer.