u/ExistingPick5055

K7 600, died as soon as I kicked it into gear and won’t prime, headlight turns off when holding ignition so I think that part is all good it just needs to prime. No fuses blown, neutral light isn’t showing on dash but rolls freely. Tried jiggling the shifter no light pop up. Won’t prime in first with clutch pulled in/not either. Here is the tip over sensor does it look bad? Also which way is supposed to face to the sky? Backstory, did a coolant flush and thermostat change and it was idling fine then died and blew the fuel fuse, I ended up reseating the tank and it now has this issue any ideas?? It won’t prime or start

Hello all I bought I bike and it’s been nothing but issues so far :/! When I can get it to run the engine sounds great shifts smoothly, 2 days ago I replaced the thermostat and coolant and turned the bike back on idling and it instantly blew the fuel fuse, 3 times when trying to find the issue, I lifted the tank once again and reseated it and it turned on fine and didn’t blow any fuse and idling fine, havnt rode since then, I have it out today idling before my ride I sit on the bike and click it into gear and it instantly turns off -_- dash lights up unlike when it was blowing a fuse, but it won’t prime when pressing the kill switch, no fuses are blown. What could the issue be? Obviously dosnt try to start when it isn’t priming

I do all the work on my bike outside fork work/engine work. Is a 450$ estimate reasonable for a fork realignment, fork seals, fork oil, steering stab realignment, and front break work. I’ve tried with them can’t figure it out -_- k7 600!