Having some trouble printing threads, everything else is perfect except the first line of the threads that get printed, tried adding in supports on the bottom, but it messes them up even worse. Any ideas? Material is PLA
Bought a service truck, it’s been sitting a little while. These are the original tires off of it, oldest one is from 5120 and newest is 1823.
I’m not a tire expert by any means, they have some spider web looking cracks on the treads, sidewalls look ok.
I’m hoping to get one more summer out of them, are they okay to run? These will only be on the drive axle, I am getting brand new steers as they are destroyed. Truck weighs approximately 11,000Lbs
Bought a service truck, it’s been sitting a little while. These are the original tires off of it, oldest one is from 5120 and newest is 1823.
I’m not a tire expert by any means, they have some spider web looking cracks on the treads, sidewalls look ok.
I’m hoping to get one more summer out of them, are they okay to run? These will only be on the drive axle, I am getting brand new steers as they are destroyed. Truck weighs approximately 11,000Lbs