I got to print my exposure test without too much problems
But if I do a normal print nothing stick to the build plate ...
Build plate comes out of the printer completely clean
There is stuff on the fep AFTER the print but I cleaned before
What would be the most likely problems?
First time printing something I wanted to do after the testing and calibration
Did not go as expected XD
First pics are what it's supposed to look like, it was printed facing "up"
Last pics are what I got, they where printed flat
Cool to see tho
I'm guessing it did that because resin pooled on the first layers ?
My first resin test printed "successfully" but I have some small bit of resin stuck on the flex plate is there a way to remove those "easily"
Just changed my film is this ok?
it feels very deep in the car casing
I got a used elegoo Saturn 4 ultra 12k with a flexible build plate already installed
Seller told it would only need a manual leveling
Manual leveling is telling me foreign objects detected
I get that I need to to stuff to the printer to make it work but I don't know the brand of the flexible build plate can I use the wham bam gcode or it would be better to remove the flexible?
(I asked for the brand, I didn't get an answer yet)
I would like to keep it because it looks quite useful but if I can't print ....