Sparkx I7 Bed Mesh - How do I correct this?
This is the best I've seen it so far after letting the bed sit heated at 55C for 10 minutes.
When its cold there was a total range of 1.5 difference.
I was having adhesion issues printing in the front corners while making a simple rectanguar print that sat on its thin side (6.5mm) and and went from the front left corner diagonally to the back right.
The front end kept coming loose about 1/4 of the way through the print job. I tried using brim and even painting supports on the end. I autocalibrate before each print.
I did not try using glue stick.
I previously had a K1SE and shimmed that bed to make it better but I'm new to this 'bed-slinger' type and not sure how or where to try shimming or if there is a better alternative.
u/Dante7235 — 6 days ago