u/DaEndeLol

So I've had a problem. My printer prints a few layers and stops extruding plastic. It keeps going up as if it's printing something and pretty sure the​​ printer tries to extrude too. It is definitely not a temp issue, either, because if i manually push it through the nozzle the plastic comes out.

i use ender 3 s1 pro

i use esun pla+ at 210°C nozzle 60°C bed

I print at about 40mm/s? Not sure ,will check later.

I use orcaslicer and octoprint

im guessing it might be too much retraction?