Some good deals came up at my local microcenter, so I decided to downsize my pc. Really had to do some careful planning and it’s a tight fit.
Is anything obviously going to harm my pc? Really only worried about the harsher bends in the AIO tubes
Pic of the old rig pre aio just for shits n gigs
Relatively new to machining (just finished a 4 year apprenticeship) and I’m astounded by what you all are capable of deducing based off chips alone.
So I think I’ve got a tough one for ya! Based off of these chips, what do you think I’m working on?
Hints: the cutting fluid is probably more telling than the chip, and I’m not using what would be considered an industry standard cutter 👀
I’m going to have posters printed of my favorite, seemingly unobtainable, pokemon cards! Going to start with this Mewtwo vstar. (Probably will do the charizard to match)
So my question for the masses is, what card arts would be worthy of such a transformation?
Maybe not relevant to the sub, but I know y’all are the best encyclopedia for pokemon!