u/Cold_Committee_8373

So, I know I've done this before - I'm running a mesh network throughout my building, and scattered about are several echo devices, cameras, lights and all kinds of crap on that network. Occasionally I do change the network password either as a precaution or because things may be acting funny or whatever. Point is I don't remember having two individually address every device, or at least I know that I have done that in the past but thought that more recently since the Euro Network the Alexa devices and the ring devices were all basically compatible did I was able to have the devices that were previously connected have the new password filtered down into them without having to go outside get up on a ladder take the back off of my devices and get some stupid 5-digit codes so I could reconnect it. Further all of my devices are being particularly finicky right now especially the echo devices... Any advice, have settings changed could my devices be out of date or am I just a little too overwhelmed and busy at the moment to remember what the hell I'm doing? Really need to get these back up and running so any thoughts would be appreciated.

Hey, I've had ring cameras and lights for years now at my home and business separate accounts with shared permissions.... Doesn't really matter but basically I'm not coming in totally new here.

My business account has old CC info and lapsed so I did update it, but after it was briefly suspended - once I didy subscription options looked new, and Unfortunately as though there is now a low options and a more expensive one?

I have 7 cameras (including a doorbell, indoor and outdoor included here, and a couple are lights and cameras combined) I have 4 or 5 lights as well. Not sure the name of the plan I picked but it's $10 or $20 monthly flat rate.

Now I can't toggle modes on my dashboard which is very annoying, they're going off constantly on phone and alexa devices, unless I manually turn off motion detection for each one.

My other thing is that I can't seem to get the schedule to work on my battery spotlight to only work for motion activated light and/or synced devices during certain timeframes. So it goes off constantly and battery diea after like 1 night.

Anybody have any experience with this recently, or how to fix. Thanks!