Has anyone gotten this new firmware yet? I just checked my printer, and it says I have the most current version (1.1.5.7). But the Anycubic support wiki is showing v1.2.0.0 as the current firmware version...
Help!
I got my 0.25mm nozzles yesterday, and the Next slicer won't let me print with it installed. When I try printing, I get a nozzle error and the print just fails!
Any ideas on how to correct this? The Next software is showing my printer with 0.4mm nozzle installed.
Also, on the prepare tab, when I choose 0.25mm nozzle, it ONLY gives me the option for Anycubic PLA filament... no other filaments are available as an option!
I am getting much better results, and a lot less stringing, by using lower temps with PLA on the Kobra X My best results have been with 220C first layer temp and 210C subsequent layer temps.
And yes, my PLA has been dried, with 15% humidity readings.
Anyone else using different temps?