I am trying to make a board game storage item that holds "Coins". The coin has a 30mm diameter and is 2.6mm thick. I want them to be stored on an angle so they don't spill all over. I have attached some screen shots of a STL I downloaded that I am trying to mimic. The images are a top down view, profile/side view and a partially angled side profile view.
What is the best way to get this geometry into the design?
A lot of my first layer prints show a discoloration see the whiteness between the two words closest to “Chips”. Any thoughts what could be causing it? I have tried to clean the plates and it still shows the issue.
Printed on H2S using the standard 0.2 quality print settings.
I am trying to split this body in half so shipping is easier. Adding in some puzzle piece features to then keep it together. However, currently I am just splitting it and the connection is so tight. Is there a way to split and also create an offset? Thanks!