u/ChemicalAd5004

I’m using orca slicer since it’s easier to see than cura on my anycubic vyper, don’t know what I changed on cura but my benchys have started to get stringing so I switched over to orca slicer and it still has the same issue but not as bad but I want to know what I could change since the quality is good
(Nozzle temp was set to 190 since higher temps make it worse) I included photos of my recent benchy with the filament I’m using along with my second benchy I printed after u got the printer

Settings are default except infill being at 10%, brim which I set to none and a 2mm layer line

It printed well, I had a chance to test the filament runout with the sample plastic it came with since the previous owner didn’t use it, you can tell where I changed the filament but like with my other printer there’s a thick line right in the middle of the cabin, anyone now a fix?

Hello, I would like to join in and use an anycubic printer but I’m broke so I’ve been scrolling on the fb marketplace and found this printer, I wanna know if these are good and if I won’t be just throwing my money away

I just wanna know since I don’t know what camera can be used for it

What’s the better option

I had to try on three different screen firmware and eventually change the printers firmware so they would both work but I finally got it to properly update and now I’m printing a bench just to see what happens

I’ve been trying to upgrade the firmware on my printer but it either updates everything BUT the screen or it updates the screen but it leaves it like in the video I added, how do I fix that