I recently installed and Openkey into my dead Hispanic street fighter zero 2 CPS2 board. This morning upon re seating the board I finally saw a flicker of life in the board. It displayed the ram check as seen in the image listing the object RAM as NG. Where do I go from here to fix this please if you could give me some pointers that would be greatly appreciated 👍
I recently installed and Openkey into my dead Hispanic street fighter zero 2 CPS2 board. This morning upon re seating the board I finally saw a flicker of life in the board. It displayed the ram check as seen in the image listing the object RAM as NG. Where do I go from here to fix this please if you could give me some pointers that would be greatly appreciated 👍
I’ve been having issues with my CPS2 street fighter zero 2 Hispanic B board, despite installing the Openkey with the correct jumpers as pictured it is still giving me a solid white screen. Ive reflowed the solder joints on the Openkey and have checked for bridges. I’ve checked the pins on the board and none are bent or dirty. I’m not sure where to go from here now so I wanted to make a post dedicated to this issues rather than just the one I made earlier checking my soldering was ok. Please let me know if there’s anything I can do to get this working 👍
How does my soldering look? I’ve only soldered a few times on my GameCube in the past and have had success but this was definitely much harder. I still need to clean the flux a little but I’ve checked and I can’t see any bridges. Please let me know👍