u/Adorable_Economist

I'm getting very inconsistent extrusion can anyone help

The printer is a Voron 0.2 with an Orbitor 2.0 and a chc v6 hotend with a 0.4mm hardened steel nozzle.

I have run through orcas calibration prints for this filament.

temp, flow rate 1, 2 and yolo 1 pressure advance, calibrated my rotation distance correctly, cleaned my extruder gears.

This cube is printed in Overture ABS at 250c hotend, 50c chamber and 100c bed temps

This is printed using speed boat rules:

3 walls, 3 top/bottom 0.25mm layers, 0.5mm line width and 10% cubic infill.