ever since I changed boards ( I changed to an asus rog strix b850-a) ive had enormously hot temps at idle (60-75) and under load anywhere from 80-95. before I never had this issue and I even replaced my cooler and repasted it several times. what could be the issue
hey guys, so I recently rebuilt my pc and i’ve noticed an issue i didn’t see before. for some reason whenever i launch games even if i have them permanently capped for example valorant, it uncaps itself on launch and i have to reset it everytime. the setting stays on yet my fps starts uncapped, anyone know why?
hey everyone. i’ve been having a microstuttering issue for a while ever since last november and im honestly at my wits end. I’ve reinstalled windows countless times, followed the ultimate amd guide multiple times, ive switched almost all of my hardware out including even my case and case cables, besides my cpu and gpu, and I had it sent to a shop and they said that they couldn’t monitor the stuttering properly. I’m absolutely at my wits end and I feel like breaking down because i’ve put hundreds of hours, tons of money, and just effort simply trying to figure this issue out. Ive done a lot of the tricks you can find and read a ton of posts involving this gpu/cpu combo as well as individual posts about the 9800x3d and the 9070xt and to no avail i’m still stuck. atp im just looking for new thoughts and insights on possible solutions, anything would help.
so I have the asus rog strix b850a gaming wifi with the peerless assassin argb 120 se. it seems that there’s not enough clearance for my fan to fully sit down and also i’ve never had this issue before really. do I have the orientation of my cooler wrong or is this normal or what
I recently bought a lancool 3 (first lian li case for me) I love all the accessories it comes with and how beautiful it is but I’ve run into an issue with building it that I genuinely don’t know what else to do. i’m using an atx motherboard and the standoffs that came pre installed with the lancool 3 don’t seem to directly line up. they’re always slightly off in some corners to the point where it doesn’t screw. i’m putting the middle most standoff in the board to help align it and it still is not helping, it’s always one entire side that won’t move or align once it’s set in place. anyone know what the problem is?