u/85genius

Just asking because I hate the messy look have taped mine back with white duct tape but still doesnt loom ideal wish they just had the ethernet sure most people don't want/need other options too?

I even considered opening the camera body up and just hardwiring cat 6 so there's only one cable coming out but was afraid of affecting the IP rating tbh think that would be the cleanest solution but would be happy with just one cable off the end with the screw on IP connector and not the extra seperate power and video leads I dont need when its always gonna just run POE

I just got a new set of 3001SE eggs, already using a pair in black and love the little things but took a punt on a set of untested silver ones on ebay because they colour match my room better.

cabinets are in excellent condition and figured even if they were electronically ruined could just swap the casings over. I repaired one of the older eggs 2001 model and those come apart really easy.

Anyway they arrive and there's a bit of a rattle on deep bass stuff cant see anything obvious at first cones look excellent but then noticed the foam port bungs have been shoved so far up inside I cant pull them out too far for pliers or even tweezers, even tried chopsticks. They are so far up to the back of the parts you can only see them with a torch shined down it, most of the bung is gonna be inside the speaker

but couple of questions:

1. how likely is it this will be causing the issue makes sense in my head that its pushed right round inside and the cone could be rattling against it or something its forced round

2. How do I get inside the damn things, older eggs had a screw on the back and were easy to get into

Any help appreciated

Hi! I just got a new set of 3001SE eggs, already using a pair in black and love the little things but took a punt on a set of untested silver ones on ebay because they match my room better.

cabinets are in excellent condition and figured even if they were electronically ruined could just swap the casings over. I repaired one of the older eggs 2001 model and those come apart really easy.

Anyway they arrive and there's a bit of a rattle on deep bass stuff cant see anything obvious at first cones look excellent but then noticed the foam port bungs have been shoved so far up inside I cant pull them out too far for pliers or even tweezers, even tried chopsticks.

but couple of questions:

1. how likely is it this will be causing the issue makes sense in my head that its pushed right round inside and the cone could be rattling against it or something its forced round
2. How do I get inside the damn things, older eggs had a screw on the back and were easy to get into

Any help appreciated