u/5stringattack

Replaced my trunk light because it was broken like every other one. I went with Brock Parts because I saw the Amazon ones are definite dog shit, well this isn't much better. I still had to remove the tab from the trunk lid along with having to shave down a mold line that went all the way around the entire light housing before it would even fit all the way in. And to wrap it up the gasket is ass and the lens sticks out further than the trunk, out of 5 I give it a meh. At least it works...for now.

Finally got back around to my tisas project, got my barrel and crown bushing blended in most of the way. Good old carbide ball bit, a hand drill, and some sandpaper. Need to still get an SA magwell along with the final grip safety, other than that I just need to send my slide for ball cuts and a french border, any recommendations on who to send the slide to?