So couple of months ago while doing some final phase testing I observed this issue where temperature sensor was reading 2-3 degrees more than usual and humidity was always less by 5 or 6 % points.
Ultimately it turned out to be the location of the TH sensor. Now this issue is resolved mostly.
What is improved now?
-> Separate PCB, Cutout where it connects to PCB and No copper under the connector
This will be done in future with software updates,
-> Low power modes & some fudge factor for you to adjust the drift!
Here are some nuggets on how it arrives from the manufacturer and enclosure modifications for this PCB.
u/IamSpongyBob — 9 days ago