My q2 chamber fan will still be running after printing using PLA. How do I automatically turn the fan off after the print cools. I am using ORCA Slicer 2.3.2 and have recently noticed that after certain prints (most recently the flow ration yolo file.
Thank you
I am trying to print the ReachSwipe that was created by MiMa3D. I am using Orca Slicer 2.3.2 and am using a QIDI Q2. When I import the file it is a single unit. I have spilt the unit into parts, but the supports show up wrong. when I assemble the handle and pad the supports look correct, however, when I print the file the handle does now move it is printed into the pad. I know I am doing something wrong but I have been unable to figure it out. I have searched several sites but cannot find a solution to what I am trying to print.
I am new to 3d printing, I have learnd much the past 4 months but I am unable to figure this out.
Thank you
