Please help :(
FIXED
I hope this helps someone because it has taken three days my life and many curse words ☺️
There is a sweet spot with the screws. I believe I tightened these (pictured in comments) too tight and the front ones too loose, causing the filament to push down on the nozzle and extend it, and giving too much slack when not printing. When looking for the plate it must have been just a few millimeters off and out of the sensors parameters. Thank you all for your input. It’s always a nice thing when you take time out of your day to help another 💜
———————————————-
Please help :(
*This is happening when it goes to sense the build plate*
It thinks my build plate is on incorrectly but it isn’t.
I have a Bambu A1 and I keep getting this error. I swear there is nothing on the nozzle and the plate is on correctly. I’ve tightened every screw and cleaned every surface. I am at a loss. Every single print is stopping.