Most of my prints have been failing for a couple of months now
I got the P2S in January and printed PLA flawlessly for 2 months, then I printed PETG and after that I rarely get a good print with PLA, all the filament is bambu.
I have done the maintenance and clean replaced the hotend. I am not sure if the PETG time line is coincidence, but I am too frustrated right now, using Gemini and ChatGPT, it says it could be Z-offset, or bed temperature or or surface contamination I have done the bed levelling calibration and my original plate has been clean with dish soap.
Is anybody else having similar issues? Any suggestions on solving it
u/jonny80 — 12 hours ago