u/generate913

I know it is risky, but I am going to try to mod my switch lite without a microscope. This is my first time, but watched a handful of videos.

My switch 1 has a scratch on the digitizer in front. I am thinking of ordering a replacement from Aliexpress to replace it. But the thing is I saw online on Reddit people saying that you need to recalibrate it after a fresh install. And the only way to do that is to use Hekate. Is that true? Do you have to recalibrate it after a fresh install?

After replacing the shell of my switch whenever I press the power button my switch lite briefly shows the Nintendo logo and shuts off again.

I had to take every component out and put it back in again for the shell swap. Maybe I misplaced a component or misattached a ribbon? Does anyone know what would be the problem if it only shows Nintendo logo screen and then immediately turns off.

Hey guys so I am about approx 70 percent done swapping my OEM shell with a ExtremeRate switch lite shell. I disassembled the XYAB buttons and assembled them back, but I noticed once assembled back the XYAB buttons sit too deep with the housing and it feels mushy/too deep needed of a press to push them in. The buttons barely rise above the housing and it feels uncomfortable to press them. I was just wondering with others who done a similar install have you guys experienced a similar issue?

I am not sure if I installed it wrong or it is just an inherent defect of the housing provided by ExtremeRate.