u/creativexploder

I am pretty new to tufting and I have some designs which have very small area or fonts in them.

How do you handle those? Are there any specific techniques for them?

What to do when the fonts are small and letter spacing is not much? How to make sure there is no thread overlapping or mix of letters when tufting as this can also cause issue during trimming and/or carving.

When I try to diagonally tuft like “A” or “R” it goes sideways and out of design

I also tried to do it with single threads instead of 2 but that too didn’t help as the gap seen was huge and threads tufted were very loose

Any tips and tricks would help based on your experience / learning.